Ascend Pipeline Guide de l'utilisateur télécharger pdf (Page 279)

Troubleshooting

Common problems and their solutions

D-2 Preliminary January 30, 1998 Pipeline User’s Guide

See “Check the installation” on page D-10 for related information.

Common problems and their solutions

This section lists problems you might encounter and describes ways to resolve

them.

General problems

When the list of DO commands appears, most operations are not available

You might need to select a specific Connection profile in order to see certain DO

commands. For example, to dial a Connection profile, you must move to the

Connection profile in the Connections menu, and then type Ctrl-D 1.

Note that you cannot dial if Operations=No for the control port. If a call is

already active, DO 2 (Hang Up) appears instead of DO 1 (Dial).

If you do not see the DO 1 (Dial) option, it may be because:

• You are not in the correct profile.

• You do not have the appropriate security level enabled.

• You have not entered a dial number in the profile.

• You have not entered an IP address in the profile (if IP routing is enabled).

Profile configuration problems

The most common problems result from improperly configured profiles.

The data appears to be corrupted on 1 Chnl or 2 Chnl calls dialed in the

U.S. to another country

On some international calls, the data service per channel is not conveyed by the

WAN to the Pipeline answering the call. You must therefore set Force 56=Yes in

the Connection profile. If you do not, the Pipeline incorrectly thinks that the call

uses 64-kbps channels.

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 320 321

Pas de commentaire

Ascend Pipeline Guide de l'utilisateur Page 279