Ascend Pipeline Guide de l'utilisateur télécharger pdf (Page 151)

Configuring IPX Routing

Configuring IPX routing connections

4-30 Preliminary January 30, 1998 Pipeline User’s Guide

Site B is a home office that consists of one PC and a Pipeline. It is not an existing

Novell LAN, so the Pipeline configuration creates a new IPX network (for

example, 1000CFFF).

Note:

The new IPX network number assigned to site B cannot be in use

anywhere on the entire IPX wide-area network. (It cannot be in use at site A or

any network to which site A connects.)

The example assumes that the Ethernet profile and Answer profile have already

been set up to enable IPX routing. Because no static routes are used, the initial

connection between the two Ascend units should be manually dialed (using the

DO menu).

To configure the Pipeline at site A:

Assign the Pipeline a name if it does not already have one.

To assign the Pipeline a name, open the System profile and specify the name

in the Name parameter. For example:

Name=SITEAGW

Open the Connection profile for site B.

Set up the Connection profile as follows:

Station=SITEBGW

Active=Yes

Encaps=MPP

Dial #=555-1212

Route IP=No

Route IPX=Yes

Bridge=No

Dial brdcast=N/A

Encaps options...

Send Auth=CHAP

Recv PW=*SECURE*

Send PW=*SECURE*

IPX options...

IPX RIP=Both

IPX SAP=Both

NetWare t/o=30

Close the Connection profile.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 320 321

Pas de commentaire

Ascend Pipeline Guide de l'utilisateur Page 151